A strange hissing noise coming from the pedal area.
Mazda 3 brake pedal goes to floor.
So at the next stop sign i went to push on the brake pedal but it pretty much went to the floor.
I suspect the master cylinder is going bad but could it be anything else.
A possible loss of power assist making the brakes really hard to push at times.
The brakes are working totally fine.
2005 mazda 3 2 3l 5 speed.
The pedal still goes to the floor.
This problem typically occurs after.
Skip to content.
The mechanic informed me that it is because of a leak in the brake.
Below we have listed five common reasons why your mazda 3 s brake pedal may be hitting the floor.
The abs came on again.
A brake fluid leak is.
Brake fluid level looks good no dash lights are on.
But i found that a.
If this bearing goes bad it will allow the brake rotor it move back and fourth which pushes the caliper piston back into the caliper creating an air gap.
3 brake pedal goes to floor.
Cx 9 owners especially those in hotter climates have been telling harrowing tales of brake problems centered around.
I tried stopping a few more times and no matter what i did the pedal went to the floor and the abs came on every single time.
The repair guy took it to a ride with me we hit the brake in a parking lot on high speeds low speeds everything it always stops properly no problem there.
A sudden loss of braking ability with super spongy pedals.
We replaced the brake master cylinder but the pedal is still soft goes a little bit down that the usual but stops say an inch before it hits the floor.
Items 1 and 2 are what you want to look at if there is a brake leak.
Axle bearings hold the brake rotor true without play while they both rotate.
The final reason for a brake pedal to go to the floor is failing axle bearing.
Items 3 4 and 5 are reasons why the pedal could sink to the floor with no leak at all.
Brake pedal goes to the floor just replaced for the second time in 2yrs the master cylinder.
Tried turning the car off and back on same problem.